SKU: LK-Y-VIK-2-3
Brand: SuperATV
Yamaha Viking 2" Lift Kit
Upgrade your machine with a SuperATV 2" lift kit. This lift kit is an easy, bolt-on system that when installed with stock tires and wheels increases your front and rear ground clearance by about 2" on average.
When combined with larger tires and wheels your machine becomes even more EXTREME. Perfect for any type of riding, whether you are on the trails, farm, hills, creek, or sand. You are sure to stand out and out perform.
SuperATV lifts are carefully machined to maintain proper angles on the vehicle and are engineered for maximum performance with enhanced handling and stability. Components are precision cut and extremely durable.
Yamaha Viking 2" Lift Kit Features:
- 2" front and rear lift
- Extremely Durable
- Will clear up to 28" tires
- Complete with all necessary hardware and easy-to-follow instructions
2018 Fitments
- 2018 Viking
- 2018 Viking VI
2017 Fitments
- 2017 Viking
- 2017 Viking VI
2016 Fitments
- 2016 Viking
- 2016 Viking VI
2015 Fitments
- 2015 Viking VI
- 2015 Viking 700
2014 Fitments
- 2014 Viking 700
FRONT: Keep all components removed from machine. Do not tighten hardware completely unless noted.
1. Remove Wheels and Shocks.
2. Remove Rectifier and Ground Wires. See Fig. 1.
- Install Rectifier to Relocator Bracket (D) with M6-1.0 x 30mm Lg. FHCS and M6-1.0 Nylock Nuts.
See Fig. 1a.
- Install assembly and Ground Wires to stock location with stock hardware. See Fig. 1a.
3. Install Front Brackets (A)(B) and Short Spacers to stock Shock Mounts. See Figs. 2 - 2a.
- Front Bracket Fore (A) installs to inside and Front Bracket Aft (B) installs to outside.
- Secure with M10-1.50 x 60mm Lg. FHCS and M10-1.50 Nylock Nuts. See Fig. 2a.
- Reinstall Shocks with M10-1.50 x 60mm Lg. FHCS and M10-1.50 Nylock Nuts. See Fig. 2a.
4. Tighten all hardware completely.
REAR: Keep all components removed from machine. Do not tighten hardware completely unless noted.
1. Remove Wheels and Shocks.
2. Install Rear Brackets (C) and Long Spacers to inside of stock Shock Mounts. See Figs. 3 - 3a.
- Use M10-1.50 x 50mm Lg. FHCS and M10-1.50 Nylock Nuts on inner holes of Rear Brackets (C).
- Use stock hardware and Long Spacers on remaining holes in Rear Brackets (C).
- Reinstall Shocks with M12-1.75 x 70mm Lg. FHCS and M12-1.75 Nylock Nuts. See Fig. 4.
3. Tighten all hardware completely.
