Polaris Ranger Midsize 500 Crew 2 Inch Lift Kit by Super ATV

124.95
Ask a question
$124.95

Availability: In Stock

This lift kit is an easy, bolt-on system that when installed with stock tires and wheels increases your front and rear ground clearance by about 2" on average.
Qty:
Add to Wishlist
Verify your product fitment.

SKU: LK-P-RAN400-2-14
Brand: SuperATV

Polaris Ranger Midsize 500 Crew 2-IN Lift Kit

Upgrade your machine with a SuperATV 2" lift kit. This lift kit is an easy, bolt-on system that when installed with stock tires and wheels increases your front and rear ground clearance by about 2" on average. When combined with larger tires and wheels your machine becomes even more EXTREME. Perfect for any type of riding, whether you are on the trails, farm, hills, creek, or sand. You are sure to stand out and out perform.

SuperATV lifts are carefully machined to maintain proper angles on the quad and are engineered for maximum performance with enhanced handling and stability. Components are precision cut and zinc plated for extreme durability.

Polaris Ranger Midsize 2-IN Lift Kit Features:

  • Front and Rear Lift
  • Zinc Plated for Extreme Durability
  • Room for Larger Tires
  • Complete with all necessary hardware and easy-to-follow instructions
Warning: This product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

2013 Fitments

  • 2013 Ranger Crew 500

2012 Fitments

  • 2012 Ranger Crew 500

2011 Fitments

  • 2011 Ranger Crew 500

Polaris RangerIN Lift Kit_LK-P-RAN400-2-14_1

Do not tighten hardware completely unless noted. Keep all components removed from machine.
Front
1. Raise machine off ground, secure with jack stands, remove Wheels and Inner Fenders.
2. Disconnect Tie-Rods from Struts.
3. Use straps to support A-Arms and remove Shocks from Shock Mount.
4. Install Lift Spacers (B) as shown in Figs. 1 - 1a.
5. Reinstall Shocks with stock components. See Fig. 1a.
6. Reinstall and trim Inner Fender Wells as shown in Fig. 2 to relieve stress on Brake Line.

7. Tighten hardware completely and reinstall necessary compone

Polaris RangerIN Lift Kit_LK-P-RAN400-2-14_3

Do not tighten hardware completely unless noted. Keep all components removed from machine.
Rear
1. Raise Cargo Bed and disconnect Wiring Harness. See Fig. 3. Note: completely removing Cargo Bed
makes for fastest installation.
2. Raise rear of machine off ground, secure with jack stands, remove Wheels, and disconnect Sway Bar.
3. Remove Shocks from top of Frame and lean inward.
4. Install Rear Brackets (A) to Frame with provided M10-1.50 x 65mm Lg. HHCS, M10-1.50 Nylock
Nuts, M10 Flat Washers, and Spacers. See Fig. 4.
5. Reinstall Shocks with stock hardware.
6. If reinstalling Sway Bar, flip over and secure with stock hardware. See Fig. 5.
7. Tighten all hardware completely and reinstall necessary components.

                                                                    (illustrations continue on following page)

Polaris RangerIN Lift Kit_LK-P-RAN400-2-14_2

Only registered users can write reviews. Please, log in or register

* Required Fields