SKU: 2748
Brand: Kolpin Powersports
IMPORTANT NOTICES
READ AND UNDERSTAND THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLATION TO AVOID INJURY TO YOURSELF, DAMAGE TO THE VEHICLE OR ACCESSORY.
For proper installation, TWO people are required.
Torque specifications must be followed when tightening bolts. Over-tightening any and/or all screws will cause cracks around mounting holes which is not covered by any warranty.
As specified on carton label, once protective film on shields is removed, product cannot be returned.
As specified on carton label, damage caused by packaging staples is not covered by warranty. All staples must be removed prior to removing product from carton.
Failure to follow these installation instructions completely may void any warrantable components and result in product damage or personal injury.
Do not use Loctite or any other similar fastener adhesive. These types of products react to plastics and cause cracking. Not covered by any warranty.
Our windshields are made from the highest quality material providing optimum transparency and clarity. Blurriness and/or extrusion marks may or may not appear when looking through windshield from a wide, side-angle. This is normal for all extruded clear plastic materials.
The application of improper cleaners, abrasive and/or dirty cleaning towels can severely damage the product. Failure to follow cleaning recommendation (provided herewith) may void any warrantable components.
DEALER
These instructions contain important information for future reference and must be given to the customer at time of purchase or upon completion of installation.
1. Installation
a) Find a clean flat area where you can safely lay down the windshield (Item A). Partially remove the protective film on both sides and apply the co-extruded bulb seal (Item B) starting at bottom center of the windshield (as shown on next page) using manual pressure to ensure good adhesion. Special cuts are required on each upper corner (the seal has an internal steel structure, a steel cutter is required). To the final joint, cut extra length by ensuring to keep ¼" longer than required. This will ensure a close fit.
IMPORTANT NOTICES
Over-tightening any and/or all screws will cause cracks around mounting holes which is not covered by any warranty.
b) Install the windshield to the vehicle using supplied hardware (Item C). Adjust the position of the windshield and tighten. Caution: over tightening any hardware could cause irreversible damage to the windshield.