SKU: 12494
Brand: Extreme Metal Products
This CNC formed and laser cut rear bumper fits perfectly on the Honda Pioneer. It is made from 11-gauge American steel and uses .188-inch steel mounting brackets for maximum durability.
This Honda Pioneer 700 Rear Bumper is powder-coated black for superior durability and protection. It installs within minutes using the included mounting brackets. No cutting or welding is necessary. All of the welds are ground smooth for safety. This rear bumper works with the dump bed. Made in the USA.
12494 Pioneer Rear Bumper Installation Instructions
Hardware:
(4) Black Carriage Bolt, 3/8-16 x 1
(4) Nut, Nyloc Flange 3/8=18
(2) Bolt, Hex Head M6 x 16
(2) Bolt, Hex Head Flange 5/16-18 x l"
(2) 5/16 Washer
(2) 5/16-18 Nyloc Nut
This will fit the Pioneer 700-4 also. The brackets have been slighty modified since these pictures were taken.
Step I: Remove the Left and Right Bed Sides and Left and Right tailgate pivot brackets according to the procedures in the Service Manual.
Step 2: Insert the L & R Pivot Brackets into the L. & R Bumper Brackets (tube wi 11 insert and face same direction as the bumper mounting flange.
Step 3: Reinstall the Pivot Brackets with the bumper brackets into the tailgate assembly and tailgate using the provided 6mm Hex Bolt (note: leave all hardware very loose until the final step).
Step 4: Insert the 5/16 Bolt thru the rear slot on the bracket and into the triangular shaped pivot mount on the machine; start the washer and nut. Note: Outside of slot accommodates installation on the 4 place Pioneer.
Step 5: Place the bumper on the brackets and insert (4) Carriage Bolts and Nuts. Snug the bumper Carriage Bolts before tightening any other hardware.
Step 6: Tighten remaining hardware beginning with the 6111111 bolt, then reinstall bed sides according to the Service Manual.
1 Item(s)
Value | |
---|---|
Quality | |
Price |
1 Item(s)