Hard Coated Polaris RZR Rear Windshield / Dust Stopper by EMP

Hard Coated Polaris RZR Rear Windshield by EMP

They say the Sahara winds bring sand all the way from Africa. In the US, companies like Polaris create machines that will kick up enough dust to blow it back. But not before you get your own dirt shower. Cut down on the debris with the Hard Coated Polaris RZR Rear Windshield by Extreme Metal Products.

EMP is an American company with a knack for quick-mounting, flush-fitting accessories, but they really thought of everything this time: Rubber Fast Straps allow you to set up and take down in seconds, smart design does not inhibit access to the rear engine trapdoor, tabbed knockouts let you customize for optional factory rear bars, and it mounts behind the cage so that harnesses can be used. Whether you’re racing through the desert, kicking up the caliche, or cruising red dirt roads, off-roading is dusty business. Get smart and put a tough polycarbonate on your cage.

Hard Coated Polaris RZR Rear Windshield Features:

• CNC Routered from Hard Coat Polycarbonate (both sides).
• 3/16"" Thick.
• Mounts behind the cage so harness can be used.
• Does not inhibit access to rear engine trap door.
• EMP Etched Logo.
• Mounts with rubber Fast Straps so you can remove it in seconds.
• Virtually unbreakable, unlike cheaper acrylic cab backs on the market.
• Made In the USA

There are tabbed knock outs for rear bars.If you are using optional factory rear bars you can easily cut out the holes for them by simply cutting the three tabs with a jig saw or hack saw.

RZR Hard Coated Cab Back
PIN: 12696
Fits: 20150-16 RZR 900

Includes:
RZR Hard Coated Cab Back
PIN: 12696
Fits: 20150-16 RZR 900
1. (1) Hard Coated Polycarbonate Cab Back
Hardware Kit;
1. (8) Rubber Fast Straps (11651)
2. (2) Metal Quick Clamps (9881)
3. (4) 1-1/4" OD x 1/4" ID Washers-Black
4. (2) 1/4-20 x 2-1/4" Flange Bolts-Black
5. (2) Spacers (5/16 x 1-1/8" Coupling Nuts)
6. (2) 1/4" wide x 1/8" thick x 2" Long Adhesive Foam
7. (1) Logo Sticker

Installation:
Note: Depending on your top you can use either the Rubber
Fast Straps or the Metal quick clamps in the top two
holes. If you are using the EMP Aluminum top you will
want to use the metal clamps on the top so you can remove
the thumbscrews to take the back off.

1. Install the Fast Straps to the poly cab back. Do not
tighten the screws yet. Leave loose until you are
done.
2. The slots on the inside of the cab back are for straps
to wrap around the horizontal tube on your cage.
You will need to use the spacers between the cab
back and the rubber straps (see fig. 3).
3. Once, everything in in place you can tighten the bolts
on the straps.
4. The Adhesive backed foam can be used in the top
comers if roll cage extensions are not used.

NOTE: If you are using aftermarket roll cage extensions
the tabs on the knock outs can be cut with a jigsaw or
hacksa