SKU: FWS-CA-MAV-001-70
Brand: SuperATV
This Can Am Maverick Flip Windshield locks into three positions to provide varying levels of comfort and protection for passengers. It is made from durable polycarbonate and is hard coated on both sides to resist scratching from road debris or heavy underbrush.
Add this flip windshield to your Can-Am Maverick for the ultimate balance of comfort and safety. With multiple adjustment positions, this windshield allows you to control visibility and air flow while providing you much-needed protection from the elements. A full-length rubber seal is contoured to the hood to provide a perfect fit!
- When assembling, do not tighten hardware completely.
- SuperATV has found that installing components to windshields on a
workbench, as shown in illustrations, makes for easiest install
Cut and install Hood Seal to bottom of windshield as shown
To ease installation, soak Seal in hot water before cutting or installing to increase flexibility
ation.
Lower Windshield (B) installation continued:
- Install Catch, part of Latch Assembly (D), to Lower Windshield (B); place Latch Support (J)
on bottom section of Lower Windshield (B) and secure with hardware shown.
Lower Windshield (B) installation continued:
- Install Lower Windshield (B) to Roll Cage with bolts included with Clamps (F).
- Install provided Gasket to Lower Windshield (B).
Upper Windshield (A) installation:
- Install Handle and Support, part of Latch Assembly (D), to Upper Windshield (A) with hardware shown.
Upper Windshield (A) installation continued:
- Install Pivot Blocks (E) to Upper Windshield (A) with hardware shown.
- Install Support (K) to Pivot Block (E) with hardware shown.
- Install Clamp (F) to lowest hole in Support (K) with hardware shown.
- Install Gas Strut (C) through Support (K) and into Clamp (F).
- Repeat for opposite side.
Upper Windshield (A) installation continued:
- Place Upper Windshield assembly onto machine and secure to Cage with Clamps (F).
- Repeat for opposite side.
- Open Upper Windshield and secure Gas Struts (C) to Pivot Blocks (E) with hardware shown.
Tighten all hardware completely.
Windshield Cleaning:
- Do not use a dry cloth, or your hands, to wipe off Windshield; Scratching will occur.
- Do not use window cleaning fluids (Windex, 409, etc) or any solvents (gasoline, denatured alcohol, acetone, etc).
- Never use abrasive cleaners, abrasive pads, or gritty cloths.